Twin Walking Wheel Assembly Complete with 80mm Wedge Solid Tyres on Wheels

Description

Twin Walking Wheel Assembly

Complete with 80WGSD Tyres on Wheels

Twin Walking Wheel Assembly Complete with 80mm Wedge Solid Tyres on Wheels

Assembly – Twin Walking Wheels are a very popular method of adding a press wheel capability to either a new or an existing bar. The popularity of these units is due to there cost effectiveness, strength to weight ratio, simplicity of design, ease of maintenance and the fact that the design has been tested, proven and improved for over 20 years. The walking beam design ensures that the unit is capable of clearing most obstacles without damage and whilst maintaining a relatively even pressure on the paired wheel. The twins are capable of being configured as standard for between 6 inch and 13 inch row spacings. On request these spacings can be extended out beyond 13 inches. All units come standard configured as a swivel or following unit, if no swivel is desireable then a simple kit is applied to lock out the swivel. This ensures that the unit can be easily reconfigured as a swivel unit at a later date. The units can be configured for low pressure (15kg) or high pressure (40kg), however most units are run at an average pressure of between 20 and 25kg. A choice of 15, 16 or 18 inch wheel sizes is available with a large number of tyre options. Units come standard with Integral Hub Press Wheels fitted with greaseable LM Tapered Bearings and Marine Seal. Cast Holden Hubs are available as an option on request. A range of other accessories are available to augment performance in some marginal conditions.

Tyre – 80mm wide mid range wedge solid tyre. This tyre is a high pressure tyre suited to rough and highly abrasive conditions where cleanability is not an issue. Tyre will give good average results across a range of soil and climatic conditions, although this tyre will build up in sticky soil as it has no ability to self clean. Tyre is good for moisture seeking and seed pressing in most conditions. Tyre has a tendency to leave paddocks rough, which is a necessity of the moisture channelling. This tyre is well suited to most seeding methods, points and boots. Recommended for very abrasive soils or very rough conditions.  Also available in a semi-solid and semi-pneumatic and Hi Flex variants.

PDF Downloads

https://ag.manutec.com.au/wp-content/uploads/2024/10/Press-wheels-info-sheet.pdf

https://ag.manutec.com.au/wp-content/uploads/2024/10/AGWALKINGWHEEL2011.pdf